Technical Articles

Why a Joint Analysis and a PCT (process capability test) of a bolted joint is required for product manufacturers. If you ask in the assembly department whether and how the users check their bolted joints AFTER assembly, there is often astonishment. Especially when already controlled, monitored and regularly tested tightening systems are used. "We assemble with high precision and monitor all parameters. Every year our tools are tested! Why should we still check the joint now? The tools always show correct values." A fallacy and source of quite a few quality defects and recourse claims in connection with bolted joints! In the following, you will find out why the analysis of bolted joints and the random execution of process inspections are so useful, why standards and guidelines specifically require them, and what the technical correlations are.

Share
Technical Articles

Unfortunately, you often only get vague or unclear answers to the supposedly simplest questions. Freedom – the SCS Concept Newsletter therefore deals in this issue with the subject of calibration

Share
Technical Articles

A tightening tool is a quite complex system – no matter if it is a torque-angle controlled EC-tool or a supposedly easy to use mechanical click wrench. If you look

Share
Technical Articles

Leading questions: Is a DKD 10-7; VDI/VDE 2648-2; XYZ calibration and the issued certificate from ACCREDIA or UKAS as good as if it had the seal from the DAkkS –

Share
Technical Articles

Tighten a joint is an operation less trivial than you might think. Tighten a screw at the rated torque is not itself a guarantee of a proper tightening stable over

Share
Technical Articles

Tighten a junction properly is a fundamental step in ensuring the quality of a production process. At the end of the production line, there is a crucial step that needs

Share
Technical Articles

Automotive example What is statistical process control? Statistical process control consists in a set of statistical tests performed on a process (for example a production line). Its goal is to:

Share
Technical Articles

Tighten the joints properly on a production line is a fundamental step to ensure the quality on the assembly process. The selection and use of wrenches, electronic or mechanical, is

Share
Technical Articles

When using click wrenches, the torque applied to the bolt is higher than the value set for the click. This happens because the operator does not stop immediately after the

Share
Technical Articles

Pulse tools generate pulses instead of continuous torque: Pulse tools must be tested on a static transducer (standalone transducer connected to a torque measuring instrument or a test bench equipped

Share